SenNet IoT Pulse Counter Sigfox Quick Start Manual page 3

www.satel-iberia.com
Type Message
SenNet IoT Pulse Counter Sigfox is an very low power device capable to measure up to 2 impulse input. Client
must select what kind of data will be uploaded to the platform, at depend of number input.
1 input counter
Type 1
Counter 1 value
Type 1
Field Info
Type data See Table 1
Byte 1
Type 2
Field Info
Type data See Table 1
Byte 1 2
2 input counter
Type 2
Counter 1 value
Counter 2 value
: Counter 1 value
Counter 1 value
Maximum 65535
2 3 4
: Counter 1 value
Counter 2 value
Counter 1 value
Maximum 65535 Maximum 65535
5 6
3 4
3
A common point in all types of messages is the head (defined with 2 bytes) that includes important information
embedded in the message (type device/type message/errors.. etc). In the next table are defined the mean of
these info-fields.
Byte Byte 1
Type Master Device Type Message
01 - Easy Meter type 0 (info)
type 1 →Counter 1
02 – Pulse Counter
type 2 →Counter 1,2
03 – TH (Temp/Hum)
type 3 (not defined)
04 - CO2-TH
type 4 (not defined)
..
05 - PM
type 15 (not defined)
06 – GW Modbus
07 – Not defined
Bit 7 6 5 4 3 2
Byte1 Byte1
Bit 7-6-5 Bit 4-3-2-1
Table 1
First message after power on the device is debug message with internal
information about build firmware. This message must be not parser by client
platform, and requeriment a donwlink message for remote settings.
Field Info
Type data See Table 1
Byte 1 2
Field Info
Byte 2
Not used Not used
Feedback Error
1 0 7 6 5 4 3 2 1 0
Byte1 Byte2 Byte2 Byte2
Bit 0 Bit 7-6 Bit 5-4-3 Bit 2-1-0
Type 0
: debug message
HW device Version FW Revision FW
3 4 5
SenNet Pulse Counter Sigfox
Not used
-
6-9