Siemens SICHARGE D 8EM5907-0AA00-1AA7.01 Operating Instructions Manual page 16

Canceling the emergency stop state
Note
Eliminate the hazardous situation
First eliminate the hazardous situation. Only then can the emergency stop state be canceled.
The Emergency Stop switch is equipped with a rotate-to-unlatch mechanism. An arrow on the
top of the button indicates the direction of rotation for unlatching. Instructions are also
shown on the display.
Unlatching the Emergency Stop button
To cancel the emergency stop state, proceed as follows:
• Turn the Emergency Stop switch in the direction of the arrow until it is released.
The charging station will automatically start to return to readiness for charging. This may take
a few minutes. The LED strips signal this process and light up in white. After a successful self-
check, the LEDs light up green. The start menu is shown on the display. The charging station
is back in normal operating mode.
Misuse of the switch
To prevent repeated pressing of the switch (misuse) and thus the failure of the charging
station without a safety-relevant reason, a wait period is introduced when the switch is
pressed before the charging station is ready for charging again. The time between repeated
pressing and the wait period can be individually configured in the Siemens Configuration
Backend (see section Siemens Configuration Backend (Page 38)).
SICHARGE D
Operating Instructions, 02/2021, 8EM5907-0AA00-1AA7.01
Safety instructions
2.3 Emergency Stop switch
15