Installing Cisco Unified Meetingplace Smtp E-Mail Gateway; Preparing For The Installation - Cisco SMTP Administration Manual

Installing Cisco Unified MeetingPlace SMTP
E-Mail Gateway
This chapter describes how to install Cisco Unified MeetingPlace SMTP E-Mail Gateway.
See the following sections:
•
•
•
•
•
•

Preparing for the Installation

To prepare for the Cisco Unified MeetingPlace SMTP E-Mail Gateway installation, complete the
following tasks:
•
•
•
If you have customized notification templates, we recommend that you save those templates in a
Note
different file or using a different extension before you install this software. This installation can
overwrite your current templates with new templates that include features that are new in this software.
You can use the templates that you save to customize the new templates. See the
Templates" section on page 4-2
OL-11018-01
Preparing for the Installation, page 2-1
Installing the Cisco Unified MeetingPlace Gateway SIM, page 2-2
Installing Cisco Unified MeetingPlace SMTP E-Mail Gateway, page 2-3
Verifying the Cisco Unified MeetingPlace SMTP E-Mail Gateway Installation, page 2-5
Stopping and Restarting the Cisco Unified MeetingPlace SMTP E-Mail Gateway, page 2-5
Uninstalling Cisco Unified MeetingPlace SMTP E-Mail Gateway, page 2-6
Verify that you have the supported system requirements by reviewing the System Requirements for
Cisco Unified MeetingPlace, at
http://www.cisco.com/en/US/products/sw/ps5664/ps5669/prod_installation_guides_list.html.
Fill in Table 2-1 so you have all of the information needed to complete the installation.
If applicable, uninstall the current release of Cisco Unified MeetingPlace SMTP E-Mail Gateway
by doing the procedure in the
section on page 2-6.
Administration Guide for Cisco Unified MeetingPlace SMTP E-Mail Gateway Release 5.4
"Uninstalling Cisco Unified MeetingPlace SMTP E-Mail Gateway"
for information about how to access the current notification templates.
C H A P T E R
"Accessing Notification
2
2-1