Table of Contents
Advertisement
with this watercraft. If you do not have one,
contact a Yamaha dealer or a fire extinguish-
er dealer to obtain one meeting the proper
specifications.
Fire extinguisher:
Classification:
B-1
Capacity:
2 lb or more
EJU40122
Safety equipment check
Check that safety equipment meeting the ap-
plicable regulations is on board.
EJU32353
Hull and deck check
Check the hull and deck for damage or other
problem.
EJU32657
Jet intake checks
Make sure that the jet intake is not damaged
or clogged with weeds or debris. If the jet in-
take is clogged, clean it. (See page 89 for in-
formation on the jet intake.)
EJU43221
Jet thrust nozzle and reverse gate check
(V1 Sport)
Check the jet thrust nozzle and reverse gate
for damage or other problem.
EJU44250
Stern drain plug checks
Loosen the stern drain plugs and remove
them, and then make sure that the plugs and
O-rings on the plugs are not damaged and
that there is no foreign material on the
threads or O-rings on the plugs. NOTICE:
Before installing the stern drain plugs,
clean the drain plug threads and the O-
rings on the plugs to remove any foreign
materials, such as dirt or sand. Otherwise,
the stern drain plugs could be damaged,
allowing water to enter the engine com-
partment. Check the O-rings on the stern
drain plugs and make sure that the plugs
are tightened securely before launching
Pre-operation checks
the watercraft. Otherwise, water may
flood the engine compartment and cause
the watercraft to submerge.
1
1 Stern drain plug
Securely install the stern drain plugs by tight-
ening them until they stop.
1 Stern drain plug
EJU41441
Hood check
Push down on the rear of the hood and make
sure that it is securely closed.
[ECJ00363]
1
60
Advertisement
Table of Contents
