Advertisement
CONNECTION TO THE TV
Optical source (TOSLINK)
Make sure the soundbar is connected to the TV or other device via Toslink optical
cable. Press the Power/Standby button on the side of the soundbar to switch to
optical mode (or via remote control).
HDMI source
Make sure the soundbar is connected to the TV or other device via an HDMI cable.
Press the Power/Standby button on the side of the soundbar to switch to HDMI
mode (or Via the remote control).
PAIRING MODE OF SUBWOOFER AND SOUNDBAR
Pairing the subwoofer and sound bar
1. Turn on the subwoofer by connecting it to a power source. The blue LED on the
back of the device will start to ash slowly. Press the WPS Auto Pairing button.
The subwoofer will enter pairing mode and the blue LED will start blinking
rapidly.
2. Turn on the soundbar by connecting it to a power source. Press the on/o
button on the sound bar (1). The sound bar goes into "pairing" mode. It will try
to connect with the wireless subwoofer.
3. Within 30 seconds, the blue LED on the back of the subwoofer will stop ashing
and stay on. This indicates that the subwoofer and the sound bar have been
successfully paired.
4. The subwoofer will automatically remember the pairing for future use.
Warning: If the subwoofer is on, but the standby mode is activated or the
device is disconnected from its power source, after 5 minutes the blue LED
indicator will turn solid red. This indicates that the subwoofer is in standby mode.
To avoid sound quality problems caused by wireless signal interference, please
keep the system at a suitable distance from other 2. 4Ghz wireless devices.
The maximum connection range is 10 meters.
6
www.PyleUSA.com
Advertisement
