Advertisement
TECHNICAL DATA
Type
Battery voltage
Saw blade dia. x hole dia.
Blade teeth
Weight without battery pack
Noise Information
levels of the tool are:
Wear ear protection!
Vibration Information
Cutting board
WARNING!
The declared vibration total values and the declared noise emission values given in this instruction manual have been measured in
accordance with a standardised test and may be used to compare one tool with another. They may be used for a preliminary assessment of
exposure.
accessories, keeping the hands warm (in case of vibration), and organising work patterns.
COMPATIBLE BATTERY PACKS (NOT INCLUDED)
WARNING! Read all safety warnings, instructions,
Failure to follow all instructions listed below may result in electric
for future reference.
CIRCULAR SAW SAFETY WARNINGS
Cutting procedures
both hands are holding the saw, they cannot be cut by the blade.
you from the blade below the workpiece.
Less than a full tooth of the blade teeth should be visible below the
workpiece.
important to support the work properly to minimise body exposure,
blade binding, or loss of control.
electric shock.
This improves the accuracy of cut and reduces the chance of blade
binding.
control.
blade washers and bolt were specially designed for your saw, for
optimum performance and safety of operation.
• kickback is a sudden reaction to a pinched, jammed or misaligned
• when the blade is pinched or jammed tightly by the kerf closing
• if the blade becomes twisted or misaligned in the cut, the teeth
If
The guard cannot protect
procedures or conditions and can be avoided by taking proper
precautions as given below.
It is
could cause the saw to jump backwards, but kickback forces can be
controlled by the operator, if proper precautions are taken.
Investigate and take corrective actions to eliminate the cause of
blade binding.
ENGLISH
L
pA
L
WA
a
=
h
saw blade, causing an uncontrolled saw to lift up and out of the
workpiece toward the operator;
down, the blade stalls and the motor reaction drives the unit
rapidly back toward the operator;
at the back edge of the blade can dig into the top surface of the
wood causing the blade to climb out of the kerf and jump back
toward the operator.
A18CS57BL
Circular saw
18 V
1.6 mm
18
pA
WA
Blades that do not match the
The
25
Advertisement
