Installation Instructions; Tools And Materials Required; Electrical Requirements - Haier GDE750AW User Manual And Installation Instructions

English
ADVERTENCIA

INSTALLATION INSTRUCTIONS

WARNING ADVERTENCIA
Risk of Fire:
CAUTION PRECAUCIÓN
CAUTION PRECAUCIÓN

Tools and materials required

• Phillips-Head and flathead screwdrivers
• Channel-lock adjustable pilers
• 1/2-inch open-end wrench
• Carpenter's level
• Measuring tape (12ft. min.)
• Duct tape
• Pipe thread sealer (Gas)
• Rigid or flexible metal 4 inch (102cm) duct
• Vent hood
Safety Warning:
1. Before starting installation, make sure that the gas shut off valve is in the
off position.
2. All old gas connectors and gas piping should be discarded.

ELECTRICAL REQUIREMENTS

Electric Dryer:
C ircuit
Individual 30 Amp branch circuit fused with 30 Amp time-delay fuses or circuit
breakers. Use seperately fused circuits for washers and dryers, and DO NOT operate
a washer and dryer on the same circuit.
P ower Supply
3 or 4 wire, 240 Volt, 1 Phase, 60Hz, AC
(Canada - 240 Volt, 1 Phase, 60 Hz, AC)
P ower Supply Cord Kit
(Not supplied when sold in US. Must be purchased to meet local electrical codes.)
The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 Type SRDT
rated at 240 Volt AC minimum, 30 Amp, with 3 open end spade lug connectors with
5
ADVERTISSMENT
ATTENTION
PRECAUCIÓN
1. Clothes dryer installation must be performed by a
qualified installer.
2. Install the clothes dryer according to the manufacturer's
instructions and local codes.
3. To reduce the risk of severe injury or death, follow all installation
instructions.
SAVE THESE INSTRUCTIONS
(GDE750AW and GDE950AW)