Table of Contents
Advertisement
Assembly Instructions for Integrated Dishwasher
Adjusting the Door Springs (Fig.5B)
The door must be perfectly balanced. In the factory , the tension
of the springs is regulated to ensure that the door is perfectly
balanced when light wood door panels are mounted on the door.
If heavier, solid wood door panels are used, the door can be
balanced by simply turning the two screws (both screws must be
turned the same amount) located on the top part of the machine.
Installation of Continuous Base Moulding
Position the dishwasher in the cut-out in the kitchen cabinet:
1.Install the continuous base moulding , following the
manufacturer's instructions .
2. Slowly open the door of the dishwasher to check to see if the
door strikes or rubs against the base moulding.
3. If so, rest the bottom edge of the panel on the base moulding
and mark the part to be cut. Leave at least 3 mm of the play
between the panel and the base moulding to allow for the door
to rotate freely (Fig.6)
4. Remove the base moulding and trim it as needed, protecting
the surface that has been cut with a paint or similar wood finish
(Fig.6)
5. Install the base moulding again (Fig.7).
How to use water-proof plastic
Firstly take off the water-proof plastic from the sticker with the
appliance (see
, Fig.8). Secondly stick it on the bottom of the
kitchen board (see
kitchen.
Positioning the Unit within the Cabinet (Fig.9)
Push the dishwasher into the cabibet opening and turn the feet
to make it level and to adjust for height so that the crosspiece
(A) for fastening it in place located on the top part of the ma-
chine comes into contact with the counter .Align the door panel
mounted on the dishwasher with the doors on the adjacent
cabinet.
Important:
The dishwasher must absolutely be fastened to the counter top
to prevent the machine from tipping when the loaded dish racks
are pulled out.
Adjustment of Back Feet (Fig.5A)
Insert the appliance in the cabinet and then adjust the height of
the machine using the screws located at the bottom front by the
special tool, included in the accessory of dishwasher.Use the
special tool to turn the screws in a clockwise direction to raise
the dishwasher and in an anticlockwise direction to lower it.
Adjustment of Door Tension (Fig.5B)
Use the special tool to turn the spring-adjusting-screw in a clock-
wise direction to tighten the door and in an anticlockwise direc-
tion to loosen it.
Notice:
If power screwdrivers are used to make the adjustment, make
the final adjustment manually with a normal screwdriver.
.5.
, Fig.8). All of this can avoid humidity in the
GB
Hide quick links:
Advertisement
Table of Contents
