Steps
1. Align and place the power-button board on the palm-rest and keyboard assembly.
2. Replace the screw (M2x3) that secures the power-button board to the palm-rest and keyboard assembly.
3. Connect the power-button board cable to the system board and close the latch.
Next steps
1. Install the
display
assembly.
2. Install the
base
cover.
3. Follow the procedure in
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
3. Remove the
heat
sink.
4. Remove the
left
fan.
5. Remove the
display
assembly.
6. Remove the
power-button
About this task
The following image(s) indicate the location of the power button with optional fingerprint reader and provides a visual
representation of the removal procedure.
42
Removing and installing components
After working inside your
Before working inside your
board.
computer.
computer.
Before working inside your