Zanussi ZWF1650 User Manual page 99

9. Select the DELAY TIME
Before you start the programme, if you wish the
starting to be delayed, choose the DELAY option.
The selected delay time value (up to 20 hours) will
appear on the display while selecting.
The end cycle will be updated and shown on the
relative position of the display.
Delay Start
No 10.55
Temp. Spin Options Change
Cancel
10. Start the programme
Press the Start/Pause button
will stop flashing. The message relevant to the phase
that is in progress will be shown in the display.
If you have chosen a delayed start, the washing
machine will begin the countdown.
Start/
Pause
11. How to change an option or a
programme during its cycle
If the programme has already started,
make any change, you must pause the washing
machine by pressing the Start/Pause button
It is possible to change any option before the
programme carries it out.
Changing a running programme is possible only by
cancelling it and selecting a new programme.
Depress twice the button Cancel to cancel the
running programme, select the new programme and
start it by depressing the Start/Pause button
The washing water remains in the tub.
Note: To drain the water before starting the new
cycle you have to cancel the programme and select
the Drain programme.
Delay Start
Start in 30 min 11.25
Temp. Spin Options Change Cancel
. The relevant light
COTTON 08.30
Washing 12.00
40°C 1200
Temp. Spin Options Change Cancel
before you
.
.
99
12. Interrupting a programme
Depress the Start/Pause button
programme which is running. Depress the same
button to start it again.
13. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door locked light will go off
and the relevant message appears in the display: the
door can be opened.
Should it not be possible to open the door, the
«Door locked» message appears in the display,
should it be absolutely necessary to do so, switch
the machine off by depressing the On/Off button.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the On/Off
button again and then the Start/Pause button
the washing machine will resume the programme
from the point where it had been interrupted.
to interrupt a
,