Electrolux PA21G Instruction Manual page 6

• Improved connection between the plug and
outlet, reducing the possibility of bad electri-
cal contact;
• Decrease in energy losses.
Be careful not to rest the appliance on the power
cord.
Plug the appliance into a dedi-
cated power outlet. Do not use
extension cords or T-type con-
nectors (benjamim). This type
of connection may cause a fire
and an overload on the electri-
cal grid impairing the perfor-
mance of your product.
For your safety, ask a qualified electrician to
check the condition of the electrical grid at the
appliance site. For details, contact the Electro-
lux Authorized Service.
The wires of the power outlet into which the ap-
pliance will be plugged must be in accordance
with NBR5410. Check that the maximum allow-
able voltage variation at the installation site is
as shown in the table below. If the supply volt-
age of the appliance exceeds the limits indicat-
ed in the Allowable Voltage Variation table, ask
the power utility company to adjust the voltage
levels or install a voltage regulator (stabilizer)
with a power of 1000VA or less.
Allowable Voltage Variation*
Voltage (V) Minimum (V) Maximum (V)
127
220
* The supply voltage levels with which this prod-
uct operates are established in the "Electric
Power Distribution Procedures in the National
Electric System (PRODIST)" of the National
Electric Power Agency (ANEEL). * If the appli-
ance comes with a 3-pin power cord plug. The
grounding pin cannot be cut.
116 133
201 231
Fixing the appliance on the wall
(optional)
Fix the template on the wall at the desired
height, make sure that it is kept level, and drill
using the appropriate materials.
Place the two bushings and se-
cure the two screws all the way.
Fit the hooks located on the back
of the appliance to the screws,
and check that the product is
fastened and leveled.
ATTENTION
Do not put any objects on the product.
Water Pipe Installation
ATTENTION
Do not turn on the appliance before finish-
ing the installation of the water pipe.
• A 3/4" gauge tap is required near the instal-
lation site. The maximum distance between
the product and the tap should be 1.5 m.
• The installation tap must provide drinkable water.
IMPORTANT
If you wish to use water from artesian or
homemade wells, it is important to have a
report that proves the indication that the
water is drinkable and that it meets the
requirements of drinkability established
by the Ministry of Health. Subsequently,
the water must be chlorinated to preserve
it from possible contamination. The max-
imum flow rate of the product is approx-
imately 2 liters/min while the tank is full.
The temperature of the mains water must
be between 4°C and 38°C and the mains
pressure between 4 and 40 mca (39.2 and
392.26 kPa) for the proper operation of the
product.
hooks
5