Wall Mount; Transport; Storage - Kärcher BC Adv Original Instructions Manual

Charging process
 Plug in the mains plug.
 Insert the battery pack into the intake of
the device.
 Device performs a self-test and the
charging process starts automatically.
 After charging, remove the battery pack
from the charger.
 Pull out the mains plug.
Note
New battery packs reach their full capacity
after approx. 5 charging and discharging
cycles.
Recharge battery packs again if they have
not been used for a long time.
The performance of the battery pack reduc-
es when temperature falls below –10 °C.
Storage for a long time at temperatures
above 40 °C can reduce the capacity of a
battery pack.
Note
The charged battery pack can remain on
the charger till it is to be used. There is no
risk of over-charging.
In order to avoid unnecessary energy con-
sumption, however, the charger should be
unplugged as soon as the battery pack is
fully charged.
14
The charger can be mounted on the wall.
Check the wall for load-bearing capacity
prior to installation. Weight of the device in-
cluding the battery pack, see "Technical
data".
The mains plug must always remain freely
accessible.
Drilled hole distance = 76 mm.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
This appliance must only be stored in inte-
rior rooms.
– 5
EN

Wall mount

Transport

Storage