freightliner Argosy COE Maintenance Manual page 98

41
1
2
05/01/95
NOTE: Not all fasteners are shown.
1. Transmission
2. Transmission Output-Shaft
End-Yoke (yoke-strap type)
3. U-Joint Assembly
4. Bearing Cap Self-Locking
Capscrew
5. Bearing Cap
greater than 0.007 inch (0.18 mm), replace both
the sleeve-yoke and the splined shaft.
7. Visually examine the driveshaft tubes for dents,
bends, twists, or other damage. If any tube ap-
pears to be damaged, see Group 41 of the
Century Class Trucks Workshop Manual for re-
pair and replacement instructions.
8. Examine the driveshaft for evidence of missing
balance weights, and for build-up of foreign ma-
terial. Remove any foreign material. If there is
any evidence that balance weights are missing,
remove the driveshaft and have it balanced.
41/2
9
8
7
10
6
5
4
3
6. U-Joint Cross
7. Bearing Cup (for yoke strap)
8. Yoke Strap and Capscrew
9. Slip-Joint Assembly
10. Sleeve-Yoke (bearing-cap type)
11. Dust Cap
Fig. 3, Components of a Basic Driveline
15
14
13
12
11
12. Splined Stub Shaft
13. Driveshaft Tube
14. Tube-Yoke (bearing-cap type)
15. Axle Input-Shaft End-Yoke
16. Rear Axle
9. For driveshafts with slip joints, check to be sure
the yoke plug is not loose or missing. See
Ref. 2. Repair or replace the yoke plug as
needed. If the yoke plug is missing, the splined
shaft may be hitting the plug and knocking it out;
contact your Regional Service Office for assis-
tance in determining the correct driveshaft
length.
Century Class Trucks Maintenance Manual, July 1999
Driveline
16
3
(yoke-strap type)
f410067b
Fig. 5,