freightliner Argosy COE Maintenance Manual page 15

00
Lubrication and Fluid Level Check: 00–04
Maintenance Operation 00–04, Lubrication and Fluid
Level Check Operation
erations that must be performed to complete the Lu-
brication and Fluid Level Check operation 00–04
called for as an M1 maintenance interval for Service
Schedule I, II, and III vehicles, and as an M2 mainte-
nance interval for Service Schedule IV vehicles.
Lubrication and Fluid Level Check for Service Schedules I, II, III, and IV
Maint.
Operation
Number
25–01 Eaton Fuller Clutch Release Bearing Lubrication
25–02 Clutch Release Cross-Shaft Lubrication
25–03 Sleeve Assembly Bronze Bushing Lubrication
26–04 Transmission Fluid Level Inspection
31–02 Fifth Wheel Lubrication
32–02 Suspension Lubrication
33–01 Knuckle Pin Lubrication, Meritor Axles
33–03 Tie Rod Lubrication, Meritor Axles
33–05 Knuckle Pin Lubrication, Dana Spicer Axles
33–06 Tie Rod Lubrication, Dana Spicer Axles
35–02 Axle Breather and Axle Lubricant Level Inspection
41–02 Driveline Lubrication
42–05 Dana Spicer Camshaft Bracket Lubrication
42–06 Dana Spicer, Haldex, and Gunite Slack Adjuster
Lubrication
46–03 Power Steering Fluid Level Inspection
46–04 Power Steering Gear Lubrication
46–05 Drag Link Lubrication
60–02 Cab Tilt Pump Reservoir Fluid Level and System Check
72–01 Door Seal, Door Latch, and Door Hinge Lubrication
Table 8, Maintenance Operation 00-04, Lubrication and Fluid Level Check for Service Schedules I, II, III, and IV
00/8
Table 8 summarizes all op-
Maintenance Operation 00–04
Operation Description
Maintenance operation numbers given in the table
are reference numbers used to help you find detailed
instructions in the manual on the lubrication or fluid
check.
Service
Schedules
I, II, and III
(at M1)
•
•
•
•
•
•
•
•
•
Century Class Trucks Maintenance Manual, January 2007
General Information
Service
Schedule IV Check
(at M2)
•
•
•
•
•
•
•
•
•
•
•
•
•