DeWalt DW920 Original Instructions Manual page 35

Have defective cords replaced
immediately
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
Charges NiMH and NiCd battery packs
See technical data for charging time
Package contents
The package contains:
1 Cordless drill/driver
1 Charger
1 Battery pack (K models)
2 Battery packs (K2 models)
1 Screwdriver bit
1 Kitbox
1 Instruction manual
1 Exploded drawing
● Check for damage to the tool, parts or
accessories which may have occurred during
transport.
● Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. A1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
1 Variable speed switch
2 Forward/reverse slider
3 Head release button
4 Mode selector /torque adjustment collar
5 Tool holder sleeve
6 Screwdriver bit
7 Battery pack
8 Release buttons
9 Charger
10 Charging indicator (red)
INTENDED USE
Your DW920 drill/driver has been designed for
professional drilling and screwdriving applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These drill/drivers are professional power tools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
Electrical Safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the
plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made
to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size
is 1 mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
E N G L I S H
33