Advertisement
Note: Left hand image shows ports marked "V1" and "V2".
Right hand image shows ports marked "C1" and "C2".
Secondary ports are uppermost in both images.
5. Apply loctite #243 to the threads of both hex head bolts (P/N 297-7091).
6. Attach hydraulic valve (P/N 353-3455) to the mounting bracket (P/N 353-3454)
as shown in Figure #2, using the two hexhead bolts (P/N 297-7091). A washer
(P/N 8T-4224) must be placed on both the head and nut end of the bolt. Secure
with nut (P/N 5C-7261).
7. Measure 570 mm (22-1/2 inches) from the compensation cylinder barrel rod end
and mark the location (refer to Figure #3).
FIGURE #1
FIGURE #2
Page 3 of 7
#C111C3
Advertisement
