JBL SDR-35 Quick Start Manual page 25

AMP Device Mode
The Device Mode button configures the remote to
control the Receiver. Pressing this button does not affect the
currently selected input on the Receiver.
The functionality of the remote is context sensitive for the
internal sources and is described in the following table.
Single press – Toggles Receiver power
2
between standby and on in the current zone
(zone in which the command is received).
Press and hold – Forces all zones into standby,
regardless of which zone the command was
received in.
0......9 The number keys can be used for direct entry
of numeric values
Sync. Delays may be introduced into the video
SYNC
signal by video processing which causes a
mismatch between the audio and video timing.
You will notice this by speech sound being out
of synchronization with the lip movements
in the video. To compensate for this, you can
adjust the lip sync delay. Press the
and use the < and > navigation buttons.
Press again to exit the lip sync trim menu.
INFO
Info cycles through the information displayed
on the lower left portion of the front panel
display when on and inputs.
,
Brings up the DTS:X dialog control adjustment.
MENU Displays the unit's setup menu on the On
Screen Display.
POP UP Toggles Dolby Volume on/off.
AUDIO Toggles Dirac Live EQ on/off.
RTN Brings up a temporary subwoofer trim control.
Use the < and > navigation buttons. Press
again to exit the sub trim control. As this
is a temporary adjustment, the sub trim level
is reset to the value set in the Speaker Levels
menu when the unit is turned off or put into
standby.
Toggles the mute function of the AVR.
VOL Adjust amplifier volume.
MODE Cycles through the available surround and
downmix modes.
DISP
Cycles through the front panel display's
brightness options
button
AMP Resets remote to mode.
AMP
DIRECT Stereo direct on/off. Provides a direct
analog path from the analog inputs to the
left and right front outputs. Switches off
any surround processing modes and shuts
down the DSP circuits.
Navigate the files and menus on the screen.
selects the highlighted file or enters the
OK
highlighted menu on the screen – equivalent
to 'Enter' or 'Select' on some remote controls.
' Up
< Left
> Right
, Down
+ ' Power on from standby
AMP
+ , Standby from Power on
AMP
+ select Zone 2
AMP OK
RED Red button.
Green button.
GREEN
YELLOW Yellow button.
BLUE Blue button.
RADIO Tuner input.
AUX Aux input.
BT input.
USB USB input.
AV AV input.
SAT SAT input.
PVR PVR input.
GAME Game console input.
BD BD input.
CD CD input.
STB STB input.
UHD UHD input.
EN-24
Network commands
When using the network client, the keys below are used to
navigate music files in Device Mode.
AMP
Navigates the files on screen.
selects/plays the highlighted file.
OK
Selects the previous/next track in the current
9
playlist.
:
Pause and playback of the current track.
4;
Stops playback.
RED Adds the currently displayed radio station to
the favourites list when using the network
client.
GREEN Removes the currently displayed radio station
to the favourites list when using the network
client.
Returns navigation to the top level of the
network client menus ('Home')