Husqvarna CL400 Operator's Manual page 9

To use the two cable blade
If the product goes away from the outer perimeter of the
workspace, it is necessary to put two cables at the same
time.
1. Plough one cable along the entire perimeter. Refer
to the figure (A) to (B).
A
START
B
START
2. When you reach the point indicated in the figure (C),
extract the blade from the soil, fasten the cable with
a stake and continue with the cable over the soil up
to the next point.
C
START
1394 - 002 - 27.11.2019
3. Fasten the cable again on a stake in the point
indicated in the figure (D).
D
START
4. Continue to plough the cable to create the island.
Refer to the figure (E).
E
START
5. When you reach the point indicated in the figure (F),
remove the stake and clean the blade. Refer to
clean the blade on page 10 .
F
START
To
9