Table of Contents
Advertisement
Installation procedures
Display of whole unit
Try to bring the packed unit to the installation place.
When it is inevitable to unpack the unit, be careful not to damage the unit. Wrap it with
nylon etc.
After unpacking, be sure to put it with the front side of the unit facing up.
Note: When delivering, don't hold plastic
parts like inlet and outlet grill etc.
Installation of outdoor unit
Selection of installation place
Place strong enough to support the unit and will not cause vibration and noise.
Place where discharged wind and noise doesn't cause a nuisance to the neighbors.
Place where is less affected by rain or direct sunlight and is sufficiently ventilated, or
to install a shield.
Place with enough space for smooth air flow.
Do not install the air conditioner on the non-special metal bracket (e.g. theft
guarding net).
If outdoor unit is street installed, it cannot be lower than 2.5m
The air outlet of outdoor unit shall be no less than 3m away from the neighbors. If
necessary, it shall get the neighbor's agreement.
Fixing of the unit
Use expansion bolt (M10) to fix the outdoor unit installation bracket on the wall.
Use bolt (M10) and nut to fix the outdoor unit on the installation bracket and keep
horizontal.
Fix outdoor unit using M10 bolt to concrete floor horizontally.
If installed on the wall or on top of a roof, bracket should be fixed securely to resist
earthquake or storms.
Use rubber pad during installation against unit vibration.
140
HPU-16CB03
Installation dimension of outdoor unit (mm)
500
140
Delivery
HPU-23CB03
24
Facing up
Advertisement
Table of Contents
