Table of Contents
Advertisement
Installation procedures
Installation of indoor unit
Selection of installation place
Place where it is easy to route drainage pipe and outdoor piping.
Place away from heat source and with less direct sunlight.
Place where cool and warm air could be delivered evenly to every corner of the room.
Place near power supply socket. Leave enough space around the unit (refer to installation
drawings).
Select the place where is firm, not easy to vibrate and can bear the weight of the unit.
When installed in bedroom, it is not suitable to let the air blow directly to the bed.
Fixing of the unit
1.
Position of the wall hole
Wall hole should be decided according to installtion place and piping direction. (refer to
installation drawings)
2.
Making a wall hole
Drill a hole with a little slope towards outside.
Install piping hole cover and seal it with putty after installation.
wall hole
( Frone section of wall hole )
Fixing of indoor unit
To prevent it from fall off, please fix the unit with fall-prevention fitting at wall and L-
shaped metal at floor.
Self-tapping
screw
wall hole
all-prevention fitting metal (accessory)
Wood screw
L-shaped metal
(accessory)
INDOOR
OUTDOOR UNIT
( Cross section of wall hole )
POWER
SOFT
SWING
Please install the whole unit horizontally,
DAMP
SET
TEMP
ON
OFF
with a slop of 1 degree at front and rear,
left and right.
25
wall thinkness
Advertisement
Table of Contents
