Timer Operation - Haier AP162ACMAA Operation Manual

Operation
Manual
Remote control unit

TIMER operation

Set Clock correctly before starting Timer operation (refer to page 5)
You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back
from outside or after you fall asleep at night.
TIMER ON/OFF
(1) After unit start, select your desired operation mode.
Operation mode will be displayed on LCD.
(2) TIMER mode selection
Press TIMER button to change TIMER mode.
Every time the button is pressed, display changes as follows:
ON
Remote
AM
12:00
controller
TIMER ON
Select your desired TIMER mide (TIMER ON or TIMEROFF) ON or OFF
will flash.
(3) Timer setting
Press HOUR /
Every time the button is pressed, time increases 10 min, If button is kept
pressed, time will change quickly.
Every time the button is pressed, time decreases 10 min, If button is
kept pressed, time will change quickly. Time will be shown on LCD. It can
be adjusted within 24 hours.
(4) Confirming your setting
After setting correct time, press SET button to confirm, "
or " " stops flashing.
OFF
Time displayed: Unit starts or stops at x hour x min (TIMER
ON or TIMER OFF)
Timer mode indicator on indoor unit lights up.
To cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
Hints
After replacing batteries or a power failure happens, Time setting should be reset.
Remote controller possesses memory function when use TIMER mode next time, just Press SET button after
mode selecting if timer setting is the same as previous one.
TEMP
OFF ON
AM
12:00
12:00
PM
TIMER OFF TIMER ON-OFF
button.
Timer on/off operation
SWING
OFF
BLANK
12:00
PM
"
ON
13
TEMP
ON
OFF
FAN
HEALTH
MODE
SLEEP SWING
SET
CLOCK
TIMER
LIGHT LOCK
RESET