Sleep Function - Haier AD212BMBAA User Manual

Operation instruction
Before going to bed, you can press the SLEEP button, the air conditioner will
operate in comfort sleep mode to make you have a sound sleep.
Before using this function, you should calibrate the clock first, otherwise, the
SLEEP function will be out of order.
Use of SLEEP function
After turning on the unit, setting the working mode, then press SLEEP button to
make the air conditioner have the previous Sleep time (powered on for the first
time or after performing Sleep is 1h). The Sleep symbol will appear. Press time
*/* button, you can choose between 1~8h. Each press, it may increase/decrease
1h and will display in the humidity area with ìxhî, and display ìTimer Offî in
Timer Off area and the time to turn off; press Sleep button again to cancel Sleep
function. The Sleep symbol disappears.
Operation modes
1.In COOLING, DEHUMIDIFYING operation
1 hour later in SLEEP operation, the temperature
will increase 1* from the set temperature,
another 1 hour later increase another 1*, then
the unit will operate continuous for 6 hours,
then it turns off automatically. The temperature
is higher than set temperature to prevent you
from getting a cold.
2.In HEATING operation
1 hour later in SLEEP operation, the temperature will
decrease 2* from the set temperature, another 1 hour later
increase another 2*, then the unit will operate continuous
at this temperature for 3 hours, then it increases 1*, after
operating at this temperature for another 3 hours, the unit
will turn off automatically. The temperature is lower than
set temperature to prevent you from feeling uncomfortable
during sleep.
Note:
lAfter setting Sleep function, it is not permitted to adjust clock.
lThe Sleep time is less than 8h, after reaching the set time, the unit will
automatically stop.
lSet Sleep function after setting ìTimer Offî function, the air conditioner will
perform Sleep function.
lAfter setting Sleep function, the Timer function cannot be set.
lSet Sleep function after setting ìTimer Onî function, the Sleep function can
only be set in the set time of Timer On.
10
Sleep operation
SLEEP operation starts SLEEP operation stops
about 6 hours
1 hour
increase 1*
increase 1*
1 hour
Set temperature
in COOLING* DEHUMIDIFYING operation
Set temperature
1 hour
decrease 2*
1 hour
decrease 2*
3 hours
SLEEP operation starts SLEEP operation stops
in HEATING operation
SET
turn off
turn off
about 3 hours
increase 1*
FAN SWING
MODE
TEMP
CLOCK SET
TIMER SLEEP
HEAT FILTER RESET
RESET
ON/OFF