Specifications - Makita SG1251 Instruction Manual

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Notch
3-1. Scale
3-2. Clamping screw
4-1. Switch trigger
4-2. Lock button / Lock-off button
5-1. Bolt
6-1. Blade case
6-2. Tool base

SPECIFICATIONS

Wheel diameter
Max. wheel thickness
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting tracks in concrete walls
or cutting in ferrous materials or concrete drainage
channels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
7-1. Shaft lock
7-2. Lock nut
7-3. Lock nut wrench
8-1. Shaft lock
8-2. Lock nut
8-3. Lock nut wrench
9-1. Blade case
9-2. Diamond wheel
10-1. Front handle
Model
Rated speed
Spindle thread
Overall length
Net weight
Safety class
noise level determined
) : 97 dB (A)
pA
) : 108 dB (A)
WA
value (tri-axial vector
2
) : 5.0 m/s
h
2
ENE026-1
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
The declared vibration emission value may also be
•
ENF002-2
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
ENG905-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
ENG900-1
Designation of Machine:
Wall Chaser
sum)
Model No./ Type: SG1251
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
3
10-2. Bolt
11-1. Dust nozzle
11-2. Vacuum cleaner
11-3. Hose
12-1. Hex wrench
12-2. Front handle
14-1. Notch
15-1. Inhalation vent
15-2. Exhaust vent
SG1251
125 mm
2.1 mm
-1
10,000 min
M14
350 mm
4.5 kg
/II
ENG901-1
ENH101-18