Cisco Aironet CB20A Configuration Manual page 54

Setting Network Security Parameters
Enabling EAP Authentication in Windows
Follow the steps in this section to enable EAP authentication in Windows for this profile.
Step 1 Click the Authentication tab. The following screen appears (see
Figure 5-13 Wireless Network Connection Properties Screen (Authentication Tab)
Note
Check the Enable network access control using IEEE 802.1X or Enable IEEE 802.1x authentication
Step 2
for this network check box if you did not enable WPA.
Perform one of the following, depending on the authentication type you want to use:
Step 3
•
•
•
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
5-54
The Authentication screen shown above appears on computers running Windows 2000 or XP.
The screen looks slightly different on computers running Windows 98, 98 SE, NT, or Me or
Windows XP Service Pack 1.
If you are planning to use EAP-TLS, go to the
If you are planning to use PEAP, go to the
If you are planning to use EAP-SIM, go to the
Chapter 5
Figure 5-13).
"Enabling EAP-TLS" section on page
"Enabling PEAP" section on page
"Enabling EAP-SIM" section on page
Configuring the Client Adapter
5-55.
5-58.
5-60.
OL-1394-08