Cisco Aironet CB20A Configuration Manual page 49

Chapter 5 Configuring the Client Adapter
c.
d.
e.
Step 16 If you imported a PAC file in
depending on your organization's policy. PAC files are similar to ID cards and should be protected from
unauthorized access. Such action would prevent exposure of the PAC by having multiple storage
locations. Contact your system administrator to determine your organization's policy on PAC security.
Refer to
Step 17
Enabling Host-Based EAP
Before you can enable host-based EAP authentication, your network devices must meet the following
requirements:
•
•
•
•
•
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-08
Uncheck the Enable network access control using IEEE 802.1X or Enable IEEE 802.1x
authentication for this network check box.
Click OK to save your settings.
If you are using Windows XP Service Pack 1, uncheck the Use Windows to configure my wireless
network settings check box on the Wireless Networks screen and click OK.
Step
Chapter 6 for instructions on authenticating using EAP-FAST.
Client adapters must support WEP and use the firmware, drivers, utilities, and security modules
included in the Install Wizard file.
The Microsoft 802.1X supplicant must be installed on your Windows device.
To use WPA, you must use a 350 series or CB20A client adapter with the software included in Install
Wizard version 1.2 or later on a computer running Windows 2000 or XP. Also, you must install
additional software with WPA support. You can download this software from the URLs provided:
Funk Odyssey Client supplicant version 2.2 (for Windows 2000)
–
http://www.funk.com/radius/wlan/wlan_c_radius.asp
Windows XP Service Pack 1 and Microsoft support patch 815485 (for Windows XP)
–
http://www.microsoft.com/WindowsXP/pro/downloads/servicepacks/sp1/default.asp
http://www.microsoft.com/downloads/details.aspx?FamilyID=009d8425-ce2b-47a4-abec-274
845dc9e91&DisplayLang=en
Meetinghouse AEGIS Client supplicant version 2.1 or later is also supported for use with
Note
Windows 2000 and XP; however, it was not tested with this client adapter software release.
You can download the Meetinghouse supplicant from the following URL:
http://www.mtghouse.com/support/downloads/index.shtml
Access points to which your client adapter may attempt to authenticate must use the following
firmware versions or later: 12.00T (340, 350, and 1200 series access points) or Cisco IOS Release
12.2(4)JA (1100 series access points).
To use WPA or fast roaming, access points must use Cisco IOS Release 12.2(11)JA or later.
Note
All necessary infrastructure devices such as access points, servers, gateways, and user databases
must be properly configured for the authentication type you plan to enable on the client.
10, you may want to consider deleting it from its original location,
Setting Network Security Parameters
5-49