Name Of Each Part - Haier AB142ACAAA Operation Manual

Name of Each Part

15.TIMER OFF Display
16.HUMIDIFICATION Display
17.TEMPERATURE Display
18.LOCK State Display
19.BATTERY Energy Display
Display when in low battery to remind
customer to change the battery.
20.STRONG/QUITE Run Display
21.SIGNAL SENDING Display
22.NEW AIR Display
23.ELECTRICAL HEATING Display
24.HEALTH Display
Display when healthy run function is set.
25.SLEEP State Display
26.Operation MODE Display
AUTO RUN COOL RUN DRY RUN
27.COMFORTABLE RUN Display
28.FAN SPEED Display
29.AUTO SWING Display
30.TIMER Display
31.FILTER Display
32.TIMER ON Display
Remote Controller' Operation
When in use, put the signal transmission
head directly to the receiver hole on the
indoor unit
The distance between the signal transm-
ission head and the receiver hole should
be within 7m without any obstacle as well.
Don't throw the controller,prevent it from
being damaged.
Clock Set
When unit is started for the first time and after replacing batteries in remote
controller, clock should be adjusted as follows:
1.Press CLOCK button,clock indication of " AM " or "PM" flashes.
2.Press or to set correct time,each press will increase or decrease
1 min. If the button is kept pressed, time will increase or decrease quickly.
3.After time setting is confirmed,press "SET" , AM or PM stop flashing,
while clock starts working.
Note:AM means morning and PM means afternoon.
FAN RUN
HEAT RUN
LO
MID
HI
O T U A
AUTO
When electronic-strated type fluorescent lamp or
change-over type fluorescent lamp or wireless
telephone is installed in the room, the receiver is
apt to be disturbed in receiving the signals so the
distance to the indoor unit should be shorter.
Loading of the battery (load the batteries
as illustrated)
Remove the battery cover
First slightly press the position marked with
and push down the cover,then as shown in the
figure:holding the upper part of the remote con-
troller with the left hand and the right hand
slightly grasps the battery box cover and forces
on the arrow direction to remove the cover.
Load the battery
Be sure that the loading is in line with the " + " " - "
pole request as illustrated on the botton of the box.
Put on the cover again
Installing the cover is opposite to removing it
Confirmation indicator
If no indication after press ON/OFF button,reload
the batteries.
Note:
Use two new same-typed batteries when loading.
If the remote controller can't run normally during
operation ,please remove the batteries and reload
them few minutes later that will be ok
If the display of remote controller is faded(someti-
mes run abnormally),which indicates no battery,so
please change the batteries
Hint:
Remove the batteries in case unit will not be in
usage for a long period.if there is any display after
taking-out just need to press reset button with a
sharp article
7
FILTER
MODE
CLOCK
SET
3
1
2
SLEEP
TIMER
LOCK RESET