Specifications - Makita GD0801C Instruction Manual

ENGLISH (Original instructions)
1-1. Lock-off lever
2-1. Lock-off lever
2-2. Switch lever
3-1. Speed adjusting dial

SPECIFICATIONS

Max. wheel point diameter
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model GD0801C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model GD0811C
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Explanation of general view
4-1. Side handle
5-1. Wrench 19
5-2. Wrench 13
5-3. Collet nut
Model
Collet size
Max. wheel diameter
Max. mandrel (shank) length
)
0
Overall length
Net weight
Safety class
noise level determined
) : 80 dB (A)
pA
) : 91 dB (A)
WA
) : 78 dB (A)
pA
value (tri-axial vector
GD0801C
Max. 8 mm
25 mm
46 mm
29,000 min
390 mm
2.0 kg
ENE050-1
Model GD0801C
Work mode : surface grinding
Vibration emission (a
ENF002-2
Uncertainty (K) : 1.5 m/s
Model GD0811C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG905-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG900-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
sum)
3
5-4. Tighten
5-5. Loosen
GD0811C
Max. 8 mm
50 mm
46 mm
-1
7,000 min
390 mm
2.0 kg
/II
2
) : 3.5 m/s
h
2
2
) : 2.5 m/s or less
h
2
-1
ENG901-1