Step 6: Installation Of The Solar Panel - Ten-Haaft SunMover Installation Instructions Manual

Step 6 : Installation of the solar panel
Place the solar panel onto the two white arms and secure it with the 6 enclosed M8
bolts and lock washers. As the bolts have different lengths, please make sure that
the longest bolt is at the bottom and the shortest is at the top. Afterwards, open
the black housing on the rear of the solar panel using a narrow fl at screwdriver to
press in the tabs. Then guide the double cable from the external unit fi rst through
E
the bores of the rectangular tube and then through the screwed connection into
the black cable box of the solar panel. Make sure that the insulating tubing is also
guided into the screwed connection.
Inside the terminal box, connect the red positive cable to the opening marked „ + „
and the brown negative cable to the opening marked „ – „. To make the connection,
fi rmly press down the terminals using a small screwdriver and insert the wire ends
into the opening. Gently pull on the cable to make sure that the wire ends are secu-
rely connected. Then press the cover back on and tighten the plastic nut.
Secure the double cable directly behind the rectangular tube using the enclosed
cable tie so that the cable cannot be trapped or pulled out of the housing in any
position of the solar panel.
Once you have installed and connected the solar panel, you can either press the
to close down the system or press key to activate solar mode.
Now you should test the safety function:
Switch the system on and wait until the solar panel has reached the correct positi-
on.
Switch on the vehicle ignition.
Verify by visual check that the external unit retracts.
Your system is now almost ready for operation. All you need to do now is calibrate
the internal compass.
39