E Step 2: Locating The External Unit - Ten-Haaft SunMover Installation Instructions Manual

Step 2: Locating the external unit
Place the external unit on the mounting plate with the connector housing and the
cable outlet of the external unit facing towards the rear of the vehicle. An ins-
tallation in any other position is not permitted and will cause the warranty to be
invalidated.
When the mounting plate is positioned correctly, the LNB and the connecting cable
E
outlet must point towards the rear of the vehicle.
Attaching the threaded elbow fi tting (cable feed-through)
The threaded elbow fi tting on the roof must be located with the cable inlet
pointing to the rear of the vehicle, thus protecting it against splash water.
To make the routing of the cables inside the vehicle easier, the distance between
the elbow fi tting and the control panel and the receiver should be as short as possi-
ble.
a) Fabricate a hole of 20 to 30 mm diameter in the roof for the cable
feed-through.
Elbow connector
ø
20-30 mm
31