Directing The Discharge Tube; Raise/Lower The Access Cover; Feed Roller Speed Control - Echo Bear Cat 76824 Owner's Manual

4.4 DIREcTINg ThE DIschARgE TubE

The discharge tube can rotate 360° and lock into different posi-
tions using the discharge lock lever. The discharge cap directs
how high and how far the chipped material blows.
Adjust the discharge tube by pressing down on the lock lever
and rotating the discharge tube until the discharge deflector
faces the desired position. Release the discharge lock lever and
slightly rotate the discharge tube until the lock pin snaps into
place in one of the holes on the base of the discharge tube (Fig-
ure 4.1).
Adjust the discharge cap by turning the knob located on the side.
Turn knob counterclockwise to loosen discharge cap. Adjust to
desired position. Turn knob clockwise to secure discharge cap.

4.5 RAIsE/LoWER ThE AccEss covER

1. Rotate the discharge chute so it is parallel to the access cover.
2. Remove the two 3/8" x 1-1/4" bolts, nuts and washers securing the access cover to the chipper housing.
3. After lowering the access cover, secure the access cover to the chipper housing using two 3/8" x 1-14" bolts, nuts and wash-
ers.

4.6 fEED RoLLER spEED coNTRoL

The feed roller speed control is used to control the speed of the
feed roller allowing the operator to have better control of mate-
rial being fed into the chipper.
For optimum chipping, it is recommended that the feed roller
operate at a faster rate for smaller branches and at a slower rate
for larger branches.
PN 18280-00 R041306
Figure 4.1 - Directing the Discharge Tube/Cap.
Figure 4.2 - Feed Roller Speed Control.
OPERATION
17