Table of Contents
Advertisement
2
AssEMbLY
Section
WARNINg
Before inspecting or servicing any part of this machine, shut
off power source, disengage the hydraulics, remove igni-
tion key and make sure all moving parts have come to a
complete stop.
2.1 TIREs AND RIMs (DoMEsTIc AND s MoDELs oNLY)
1.
Mount tires and rims to the axle using the lug nuts.
2.
Attach the fender supports to the trailer using three 1/2" x 3-1/2" hex bolts, washers & nuts.
3.
Attach the fenders to the fender supports using four 3/8" x 1" carriage bolts, washers and nuts.
2.2 TRAILER hITch (DoMEsTIc AND s MoDELs oNLY)
S & F-MODELS:
1.
Thread the wire harness through the hitch tube and slide
the hitch tube into the trailer frame. Secure using two 1/2" x
4-1/2" bolts, washers and nuts (provided in owner's kit).
2.
Slide the hitch coupler onto the hitch tube from the top and
secure using 1/2" bolts, nuts and washers.
3.
Thread the wire harness through the metal loop on the un-
derside of the coupler.
2.3 REAR sTAbILIzER
verify that the rear stabilizer is installed. To install the rear stabilizer, slide the stabilizer into the corresponding bracket beneath the
rear of the chipper frame. Adjust the stabilizer and secure with the provided snap pin.
2.4 chEckINg/ADDINg MoToR oIL To ENgINE
Check the oil level and, if needed, fill the engine crankcase with the type and amount of oil specified in the engine owner's manual.
10
IMpoRTANT
If any bolts or nuts are dropped in the machine, be sure to
remove them before starting the machine. Remove items
from the shredder area by removing the discharge screen.
DOMESTIC MODELS:
Thread the wire harness through the hitch tube and slide the
hitch into the trailer frame. Secure using two 1/2" x 4-1/2" bolts,
washers and nuts (provided in owner's kit).
PN 18280-00 R041306
Advertisement
Table of Contents
