Hilti NCR 060 II-A22 Original Operating Instructions page 25

Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
5.6 Crimping 2
DANGER
Electric shock hazard! Working in adverse outdoor conditions can cause electric shocks and/or short
circuits.
▶ Never work on electrically live lines while a thunderstorm is in progress.
▶ Call a halt to work immediately whenever weather conditions impair the insulation characteristics, vision
or movement of the workers.
WARNING
Danger! Risk of fire due to faulty crimping.
▶ Use only cable terminals of the correct type and size for the cable. Failure to observe this point can result
in faulty crimping.
▶ Listen for the signal tone and check that the piston has retracted. If no signal tone is heard or if the piston
does not retract then the crimping is faulty.
WARNING
Risk of injury! If not aligned flush, lever and pivoting bar can fly out like projectiles.
▶ Before and during the crimping operation, make sure that lever and pivoting bar are correctly aligned.
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting the parts to be connected, i.e. crimped.
WARNING
Risk of injury due to oil escaping under high pressure! Oil escaping under high pressure can injure the
skin and the eyes.
▶ Do not use the crimping tool if damage is visible.
▶ Do not use the crimping tool if oil escapes.
▶ Make sure that the piston retracts after every crimping operation.
▶ If the piston does not retract after the crimping operation, press the reset button for manual retraction.
WARNING
Risk of injury due to flying fragments! Flying fragments present a risk of injury to the eyes and body.
▶ Wear eye protection and protective gloves.
▶ Use suitable connecting material in combination with the correct crimping / pressing dies.
▶ Before and during the crimping operation, make sure that the crimping jaws are correctly positioned.
CAUTION
Short-circuit due to formation of flash produced by crimping operations! Faulty crimping can lead to
the formation of flash, which can cause short-circuiting/arcing.
▶ Use the correct crimping / pressing die.
▶ Use suitable connecting material.
▶ Remove the flashes that form in the course of crimping work.
1. Open the lever and pivoting bar and insert the connector in the die.
2. Close the pivoting bar and the lever.
*2207049*
2207049 English 21