Philips SCD465 Instructions For Use Manual page 8

EngliSh
8
- It takes at least 14 hours to charge the batteries fully.
- When the batteries are fully charged, the charging light gradually dims. You can then take the
parent unit out of the charger.
- When the power-on light of the parent unit blinks red, the batteries are low. Put the parent unit
in the charger to recharge the batteries.
using the appliance
1 Place the two units in the same room to test the connection. (Fig. 6)
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
 Press the on/off button to switch on the baby unit. (Fig. 7)
The power-on light starts to burn green.
,
 Turn the volume control to switch on the parent unit and to set the volume to the level you
prefer. (Fig. 8)
The power-on light starts to burn green.
,
When a connection has been established between the units, the connection light on the
,
parent unit starts to burn green.
Note:It takes about 30 seconds before a connection is established.
 Place the baby unit at least 1 metre/ feet away from your baby. (Fig. 9)
5 Position the parent unit within the operating range of the baby unit. Make sure it is at least 1
metre/ feet away from the baby unit. For more information on the operating range, see
section 'Operating range' below. (Fig. 10)
Operating range
The operating range of the baby monitor is 200 metres/600 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller.
Dry materials
Wood, plaster, plaster cardboard, glass
(without metal, wires or lead)
Brick, plywood
Reinforced concrete
Metal grilles or bars
Metal or aluminium sheets
For wet and moist materials, the range loss may be up to 100%.
Features
Channel selection
Always make sure that the channel selectors inside the battery compartments of both units are set
to the same channel. With these channel selectors, you can select sixteen different channel positions.
If you experience interference from other baby monitors, radio devices, etc. select a different
channel.
1 Open the battery compartment lids of both units.
Parent unit: turn the locking knob in the bottom a quarter turn (1) and slide the battery
,
compartment lid downwards to remove it (). (Fig. 11)
Baby unit: turn the locking knob with a coin and remove the lid. (Fig. 1)
,
4222.002.6422.1.indd 8
Material thickness
<30cm/12in
<30cm/12in
<30cm/12in
<1cm/0.4in
<1cm/0.4in
Loss of range
0-10%
5-35%
30-100%
90-100%
100%
14-04-2006 08:51:54