Table of Contents
Advertisement
20
Using the TV
Remote control item
Indicator light
Setup
PWR
TV, CBL/SAT, DVD/VCR,
or HP.PC
Keypad
Mute
VOL
CH. RTN
HP.MC
CH
Guide
Exit/Back
Up/down/left/right
buttons
Enter
Description
The red light blinks once each time a button is
pushed. If the red light blinks two times when a
button is pushed, the remote control batteries are
low and need replacement.
Use the SETUP button when programming the
remote control for component control.
Press PWR once to turn on or off the selected
home entertainment component.
Press one of these buttons once to select a home
entertainment component to control. HP.PC selects
the HP Media Center PC (connected to the VGA
or DVI connector) and enables the HP MCPC
special buttons on the remote. To program the
remote control to operate a cable or satellite set-
top-box, or a DVD, or a VCR, see "Programming
the remote control for component control" on
page 22.
Use the keypad (0–9, +10) to directly select
channels.
Press MUTE once to turn sound off or on.
Use VOL+ (or VOL–) to raise (or lower) the sound
volume.
Press CH. RTN (channel return) once to recall the
last channel or to page back one screen in the
main menu.
Press HP.MC to Start Media Center when using
the HP Media Center PC.
Use CH+ (or CH–) to select the next higher (or
lower) channel.
Use GUIDE to display the program guide for a TV
set-top-box or for HP MCPC.
Use EXIT to exit out of the selected component's
menu or guide. Use Back for the HP MCPC.
Use these cursor buttons to move the cursor in a
program guide or in menus.
Press ENTER once after entering channel numbers
on some TV models. Use Enter as the OK button
for the HP MCPC.
Use Enter to bring up the OSD.
Advertisement
Table of Contents
