HP xp8010 series Reference page 9

Example — changing input source
The following simplified example shows how the projector typically responds to a
request to change the active input source. Note that the three latter notifications are
delayed.
Request:
Notifications:
Example — changing the picture mode
A request to change the picture mode can take a moment to complete, and so produces
a delayed notification. In this example, the picture mode is initially set to 0.
Request:
Notifications:
Example — turning on the projector
Request:
Notification:
Request:
Notifications:
RS-232 protocol reference
*RSRC=2<CR>
*RSRC=2<CR><LF>
*SRC=0<CR><LF>
*SRC=2<CR><LF>
*BRT=50<CR><LF>
*CSPC=?<CR><LF>
*PMOD=1<CR>
*PMOD=0<CR><LF>
*PMOD=1<CR><LF>
*STAT=?<CR>
*STAT=0<CR><LF>
*W<CR>
*W<CR><LF>
*STAT=2<CR><LF>
*STAT=1<CR><LF>
(acknowledges request)
(projector is attempting to
acquire source 2, and in the
interim has no valid source)
(source 2 has been acquired
and is now active)
(brightness has been modified
for source 2)
(color space is not supported
for this input)
(current setting)
(new mode is active)
(current setting)
(echoes request)
(projector enters its warm-up
state)
(projector enters its on state)
9