Maintenance And Cleaning - Princess 212024 User Instructions

product. Put the lid back on the jug
before switching the blender on again.
6 Switch off the blender once you have
processed the required quantity of fruit
and/or vegetables.
7 Remove the plug from the wall socket.
• Never allow the power cord to hang
over the edge of the draining board,
worktop or table.
• Never use the appliance outdoors.
• Use an earthed wall socket.
• Never use the appliance in a humid
room.
• Always remove the plug from the wall
socket after use.
• Make sure your hands are dry when
you touch the appliance, the power
cord or the plug.
• Switch off the appliance and remove
the plug from the wall socket in the
event of a malfunction during use,
before cleaning the appliance, before
fitting or removing an accessory and
before storing the appliance after use.
• Take care when touching the
appliance and its parts. Allow the
appliance to cool down first. The
appliance and its parts will become
hot whilst the appliance is in use. The
appliance's housing will also become
hot, since the housing is an excellent
conductor of heat.
• Never leave the appliance unattended
when in use.
• Always close the lid before switching
on the appliance.
• Hot liquids in the blender may result in
the lid flying off due to the steam and
pressure caused by the hot liquid.
Prevent this from happening by
holding the lid down with a cloth
whilst the blender is in use.
• The blender works very quickly. The
ingredients are ground within just a
6
Article 212024 Princess Arctic Blender
few seconds. The longer the blender
is switched on, the finer the products
will be ground.
• To overcome overheating, do not
switch on the blender longer as three
minutes continuously.
• Never let the appliance operate with
an emty jug.
Maintenance
and Cleaning
1 Remove the plug from the wall socket.
2 Clean the housing of the appliance with
a soft, damp cloth.
3 Turn the ring loose from the bottom of
the jug and remove the knife and the
rubber sealing ring.
4 Clean the jug, the knife, the sealing
ring, the lid and the lid insert in warm
soapy water.
5 Rinse all parts with fresh water.
6 Dry all parts.
7 After cleaning position the knife with the
rubber sealing to the bottom side of the
jug and fixate it by turning the ring on
the jug.
8 Fit all the parts to the blender (see
'Fitting the parts'), close the lid, and
store the appliance.
• This blender uses sharp knives, which
are located in the bottom of the
container. Therefore, be very careful
when emptying and cleaning the
blender. Avoid cutting yourself on the
knives.
• Make sure no moisture comes into
contact with the appliance's electrical
parts.
• Never immerse the appliance, the
power cord or the plug in water or
other liquids.