Advertisement
MIL will display the appropriate amount of holdover in
milliradians to use, which is based upon the ballistics group
and sight-in distance you will choose in a later mode. The
upper display shows the line of sight distance to the target.
The lower display will briefly show whether you should hold
high or low, then the appropriate number of mils to hold
over or under. In the example to the right, the line of sight
distance is 484 yards, and the lower display indicates that you
should hold 2.9 mils above your intended point of impact.
Holdover values will be displayed in mils for both yards and
meters modes.
MOA Mode will show the minute-of-angle adjustment for
your target which is based upon the ballistics group and sight-
in distance you will choose in a later mode. The upper display
shows the line of sight distance to the target. The lower
display will briefly show whether you should dial the scope
in the up or down direction, then the appropriate number
of MOA adjust. In the example to the right, the line of sight
distance is 484 yards, and the lower display indicates that you
should dial the scope up 10.1 MOA to account for bullet drop.
16
Advertisement
