Final Checks (With The Burner Working) - Riello RS/M Series Installation, Use And Maintenance Instructions

5.10 Final checks (with the burner working)

 Open the control limit operation
 Open the high limit operation
 Rotate the maximum gas pressure switch knob to the mini-
mum end-of-scale position
 Rotate the air pressure switch knob to the maximum end of
scale position
 Switch off the burner and disconnect the voltage
 Disconnect the minimum gas pressure switch
 Disconnect the plug of the ionization probe
Make sure that the mechanical locking systems on
the different adjustment devices are fully tightened.
WARNING
Start-up, calibration and operation of the burner
33

The burner must stop

The burner must stop in lockout

The burner must not start

The burner must stop in lockout due to firing failure
GB
20160778