Table of Contents
Advertisement
13.3 Exiting the basic settings
14 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the diameter of the cook-
ware base corresponds to the diameter of the cooking
zone being used.
Access is via the basic settings. → Page 16
14.1 Procedure for checking the cookware
Set the cookware at room temperature with approx.
1.
200 ml water in the centre of the cooking zone
whose diameter best fits the diameter of the base of
the cookware.
Call up the basic settings and select .
2.
Touch or . The
3.
zones.
a The function has been activated.
a After 20 seconds, the result appears in the cooking
zone displays.
15 Basic operation
15.1 Switching on the appliance
Turn the function selector to any position other than
▶
the "Off" position .
a The appliance is switched on.
15.2 Switching off the appliance
Turn the function selector to the "Off" position .
▶
a The appliance is switched off.
15.3 Types of heating and temperature
Use the function selector to set the type of heating.
1.
Use the temperature selector to set the temperature
2.
or grill setting.
a The appliance starts heating after a few seconds.
16 Rapid heating
To save time, you can use the rapid heating to shorten
the preheat time.
Only use rapid heat-up when a temperature of over
100 °C has been set.
After rapid heating, it is best to use the following types
of heating:
¡ 3D hot air
¡ Top/bottom heating
display flashes in the cooking
To exit the basic settings and and switch off the
▶
hob, touch
.
14.2 Checking the result
In the following table, you can check the result for the
quality and speed of the cooking process:
Result
The cookware is not suitable for the
cooking zone and therefore does not
heat up.
The cookware is taking longer to heat
up than expected and cooking is not
progressing as well as it ought to.
The cookware is heating up correctly
and cooking is progressing well.
1
If a smaller cooking zone is available, test the cook-
ware on this cooking zone.
Touch or
to activate the function.
When the dish is ready, switch off the appliance.
3.
Tips
¡ The most suitable type of heating for your food can
be found in the description of the types of heating.
¡ You can also set a cooking time and an end time
on the appliance.
→ "Time-setting options", Page 18
Changing the type of heating
You can change the type of heating at any time.
Use the function selector to set the required type of
▶
heating.
Changing the temperature
You can change the temperature at any time.
Turn the temperature selector to set the desired
▶
temperature.
16.1 Setting rapid heating
To ensure an even cooking result, do not place the
food in the cooking compartment until rapid heating
has come to an end.
Use the function selector to select rapid heating .
1.
Use the temperature selector to set the required
2.
temperature.
a Rapid heating starts after a few seconds.
a When the rapid heating process ends, an audible
signal sounds and the heating indicator goes out.
Cookware test en
1
1
17
Advertisement
Table of Contents
