HP xw4100 Hardware Installation Manual

Scsi hard drive installation hp workstation xw series
Hide thumbs Also See for xw4100:
Table of Contents

Advertisement

Available languages

Available languages

This document describes how to install a SCSI hard drive into an HP Workstation xw series.
Installing the New Hard Drive
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
Å
components to cool before touching.
CAUTION: Be sure that the power to the workstation is off. Disconnect the AC power cord to avoid
Ä
electrical damage to the workstation. Electrostatic discharge (ESD) can damage electronic components.
Be sure you are properly grounded before beginning this procedure. For more information, refer to the
Service and Technical Reference Guide for your HP workstation at
http://www.hp.com/support/workstation_manuals.
NOTE: For product-specific information, refer to the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
NOTE: HP strongly recommends that only an HP authorized dealer, reseller, or service provider replace
your primary hard drive.
NOTE: HP accessories are for use in HP workstation products. They have been extensively tested for
reliability and are manufactured to high quality standards. HP, therefore, warrants only those accessories
that are manufactured or sold by HP.

Setting the SCSI ID

Before installing a SCSI hard drive in your system, you must give the hard drive a unique SCSI ID.
All SCSI controllers require a unique SCSI ID (0-15) for each SCSI device that is installed. The reserved
and available SCSI ID numbers for SCSI devices are:
■ 0 is reserved for the primary hard drive (not reserved for the primary hard drive on Linux).
■ 7 is reserved for the SCSI controller.
■ 1 through 6 and 8 through 15 are available for all other SCSI devices.
When 0 is used for the primary hard drive, set the second hard drive to 1, the third to 2, and so on.
SCSI Hard Drive Installation
HP Workstation xw Series

Advertisement

Table of Contents
loading

Summary of Contents for HP xw4100

  • Page 1: Setting The Scsi Id

    SCSI Hard Drive Installation This document describes how to install a SCSI hard drive into an HP Workstation xw series. Installing the New Hard Drive WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system Å...
  • Page 2: Installing The Hard Drive

    Installing the Hard Drive After you have given the hard drive a unique SCSI ID, you can install the hard drive into your system. NOTE: For product-specific information, refer to the Service and Technical Reference Guide for your HP workstation at http://www.hp.com/support/workstation_manuals.
  • Page 3 5. Push the drive into the selected bay until it snaps into place. Then attach the power and data cable to the drive. NOTE: For an HP Workstation xw4200, install two 6-32 screws into each side of the hard drive before sliding the hard drive into the bay.
  • Page 4: Configuring The Workstation

    SCSI Controller Card 1. If you have not already done so, follow the applicable instructions for “Installing the Hard Drive.’’ 2. Insert the SCSI controller card into an available PCI expansion slot. 3. Connect the SCSI cable to the SCSI controller card. 4.
  • Page 5 21. Click Finish to create the partition and begin the format process. Creating a Partition Using Windows 2000 To create a partition for the new drive using Windows 2000: 1. From the desktop click Start, point to Settings and click Control Panel. 2. Click Administrative Tools. 3. Click Computer Management.
  • Page 6 Before choosing the partition type, be aware that Red Hat Linux (which is most likely installed on your HP system) only allows up to four primary partitions per disk. If you wish to create more than that, one (and only one) of the four primary partitions may be an extended partition, which acts as a container for one or more logical partitions.
  • Page 7 6. Repeat this process until you have created your desired partitioning scheme. NOTE: By entering w, you are permanently destroying any data that currently exists on the device. If you need to preserve any data, enter q to exit the program without altering the disk. Formatting an ext3 File Systems with mkfs After you have created partitions on the disk drive using a partitioning program such as fdisk, use mkfs to create an ext3 file system on each partition.
  • Page 8: Technical Support

    Technical Support Phone or Online ■ Contact your local HP technical support provider. ■ You can get additional information by visiting the HP Web site at www.hp.com/support. Warranty Refer to the warranty information that was shipped with this kit. 366429-001 ©...
  • Page 9 SCSI ハー ド デ ィ ス ク ド ラ イ ブのイ ン ス ト ール HP Workstation xw シ リ ーズ 本書では、 SCSI ハー ド デ ィ ス ク ド ラ イ ブ を HP Workstation xw シ リ ーズに イ ン ス ト ールす る 方 法を説明 し ます。...
  • Page 10 ク ド ラ イ ブ を イ ン ス ト ールで き ます。 注記 : 製品固有の情報は、 以下の Web サ イ ト でお使いの HP ワー ク ス テーシ ョ ン用の 『Service and Technical Reference Guide』 を参照 し て く だ さ い。...
  • Page 11 デー タ ケーブルを ド ラ イ ブに接続 し ます。 注記 : HP Workstation xw4200 の場合は、 ハー ド デ ィ ス ク ド ラ イ ブ をベ イ に挿入す る 前に、 6-32 ネジ 2 本 を ド ラ イ ブの両側に取 り 付け ます。...
  • Page 12 以下の図に、 SCSI ハー ド デ ィ ス ク ド ラ イ ブ を取 り 付けた xw8200 を示 し ます。 6. デー タ ケーブルを シ ス テ ム ボー ド の SCSI コ ネ ク タ ( ワー ク ス テーシ ョ ン の底面近 く を確 認、...
  • Page 13 SCSI コ ン ト ロー ラ カ ー ド 1. ハー ド デ ィ ス ク ド ラ イ ブ を ま だ イ ン ス ト ール し ていない場合は、 「ハー ド デ ィ ス ク ド ラ イ ブの イ ン ス ト ール」 の手順に従い ド ラ イ ブ を イ ン ス ト ール し ます。 2.
  • Page 14: Windows 2000

    Windows XP でのパーテ ィ シ ョ ンの作成 Microsoft® Windows® XP で新 し い ド ラ イ ブにパーテ ィ シ ョ ン を作成す る には、 以下の手順で行 い ます。 1. デス ク ト ッ プか ら [ ス タ ー ト ] を ク リ ッ ク し 、 [ コ ン ト ロ ール パネル ] を ク リ ッ ク し ます。 2.
  • Page 15 5. [ デ ィ ス ク の管理 ] を ク リ ッ ク し ます。 [Write Signature and Upgrade Disk] ウ ィ ザー ド が起動 し ます。 [ キ ャ ン セル ] を ク リ ッ ク し 、 ウ ィ ザー ド を中止 し ます。 6.
  • Page 16 パーテ ィ シ ョ ン の種類を選択す る 前に、 Red Hat Linux (お使いの HP シ ス テ ム に、 おそ ら く イ ン ス ト ール さ れてい ます) では、 1 台のデ ィ ス ク につ き 最大 4 つのプ ラ イ マ リ パーテ ィ...
  • Page 17: テ ク ニ カル サポー ト

    テ ク ニ カル サポー ト 電話も し く はオ ン ラ イ ン ■ お近 く の HP のサポー ト 窓口に連絡 し て く だ さ い。 ■ 追加情報は、 以下の HP の Web サ イ ト で入手で き ます。...
  • Page 18 © 2004 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. Microsoft お よ び Windows は、 米国におけ る Microsoft Corporation の登録商標です。 Linux は、 米国におけ る Linus Torvalds の登録商標です。 366429-001...

Table of Contents