HP xw3100 Getting Started Manual page 23

Diagnostic Front Panel Lights (LEDs) and Audible Codes (Continued)
Activity
System does not
power on and
LEDs are not
flashing.
Beeps Possible Cause
None System unable to
power on.
Recommended Action
Press and hold the power button for less
than 4 seconds. If the hard drive LED
turns green, then:
1. Check that the voltage selector,
located on the rear of the power
supply, is set to the appropriate
voltage. Proper voltage setting
depends on your region.
2. Remove the expansion cards one at
a time until the 3.3 V_aux light on
the system board turns on.
3. Replace the system board.
OR
Press and hold the power button for less
than 4 seconds. If the hard drive LED
does not turn on green then:
1. Check that unit is plugged into a
working AC outlet.
2. Open hood and check that the
power button harness is properly
connected to the system board.
3. Check that both power supply
cables are properly connected to
the system board.
4. Check to see if the 3.3 V_aux light
on the system board is turned on. If
it is turned on, then replace the
power button harness.
5. If the 3.3 V_aux light on the system
board is not turned on, then
replace the power supply.
6. Replace the system board.
www.hp.com
Getting Started
19