HP Workstation x1000 Supplementary Manual page 9

Removing and replacing the processor

Hide thumbs Also See for Workstation x1000:

4. Place a new thermo-interface compound on top of the processor. This is a small

square sheet of foil with a black wax coating on both sides of it. See Figure 9.

Figure 9. Replacing the Thermo-Interface Compound

5. Replace the processor's heat sink and fan on the system board by aligning the

fan and heat sink as shown in Figure 10. Next, tighten the heat sink mounting

screws.

Figure 10. Removing the Processor's Heat Sink and Fan

Table of Contents