3: Ip Address Configuration - Sena NEMO10 User Manual

3: IP Address Configuration

A valid IP address of the NEMO10 needs to be assigned before it starts to work in the user's network
environment. A network system administrator may provide the user with this IP address setting
information for the network. The IP address must be unique within the network. Otherwise, the
NEMO10 will not have a valid connection to the network.
Users can choose the desired IP mode out of the three IP operating modes, i.e., Static IP, DHCP and
PPPoE. The factory default IP mode is DHCP mode. Table 3-1 shows the parameter items for IP
configuration.
Static IP
DHCP
PPPoE
Basic ' set'command usage for IP configuration is as follows:
set ip ipmode par1 par2 ...
where,
ipmode: ' static'for Static IP / ' dhcp'for DHCP / ' pppoe' for PPPoE
parameters:
if ipmode = static,
par1 = IP address, par2 = subnet mask, par3 = gateway
if ipmode = dhcp,
no parameters required
if ipmode = pppoe,
par1 = PPPoE username, par2 = PPPoE password
Table 3-1 IP configuration parameters
IP address
Subnet mask
Default gateway
No parameters required
PPPoE username
PPPoE password
26