SATO ARGOX IX4 Series Quick Start Manual page 2

Configuring Your LAN Printer by Web Setting Tool
Before doing settings for your printer, be sure that you have a LAN cable. The cable is
connected to the LAN connector of your printer. The LAN connector is an 8-PIN
RJ45 type modular connector. Please use the LAN cable of CAT 5 of a proper length
to connect the LAN connector on the printer to a LAN hub as appropriate.
The default static IP address of the printer is 0.0.0.0 and the default listen port is 9100.
For the first time, to configure your printer through the web setting tool, you must still
follow the step-by-step instructions below.
Attaching the power cord
1. Make sure the printer power switch is set to the OFF position.
2. Insert the power supply's connector into the printer power jack.
3. Insert the AC power cord into the power supply.
Important: Use only the power supply listed in the user instructions.
4. Plug the other end of the AC power cord into the wall socket.
Do not plug the AC power cord with wet hands or operate the
printer and the power supply in an area where they may get wet.
Serious injury may result from these actions!
Connecting your LAN printer to a LAN hub
Use a LAN cable of CAT 5 of a proper length to connect the LAN connector on the
printer to a LAN hub to which your desktop or laptop PC as a host terminal is also
connected.
Getting the IP address of your LAN printer
You can have the printer run a self test to print a configuration label, which helps you
get the IP address of your printer connected to the LAN hub.
1. Turn off the printer.
2. Press and hold the FEED button, and turn on the printer.
3. Both status lights glow solid amber for a few seconds. Next, they turn to green
shortly, and then turn to other colors. When LED 2 turns to green and LED 1 turns
to amber, release the FEED button.
4. Press the FEED button to print a configuration label.
5. Get the IP address of the printer from the printed configuration label.