Cisco Catalyst C9200L-24PXG-4X-E Hardware Installation Manual page 36

Connecting to the StackWise Ports
Figure 21: Connecting the StackWise Cable in a StackWise Port
1
c) Finger-tighten the screws in clockwise direction.
Step 5
Connect the other end of the cable to the port on the other switch and finger-tighten the screws. Avoid
over-tightening the screws.
Caution
When you need to remove the StackWise cable from the connector, make sure to fully unscrew the correct
screws. When the connectors are not being used, replace the dust covers.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
30
Connector screws
Removing and installing the StackWise cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary (installing and removing it up to 200 times is
supported).
2 StackWise cable
Installing the Switch