Table of Contents
Advertisement
Malfunction
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
fizzing, hissing
loud.
Loud noise during
spin.
Clapping, clattering
in the pump.
Slurping, rhythmic
suction sound.
wrinkling.
Cause and Troubleshooting
Start the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
The imbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Water is flushed into the detergent drawer under
pressure.
No error - normal operating noise.
▶
The appliance is not leveled properly.
→ †Adjusting the device", Page 17
▶
Device feet are not fixed.
Secure the device feet.
▶
→ †Adjusting the device", Page 17
Transport protections have not been removed.
→ †Remove transport locks", page 14 †
▶
A foreign object has entered the pump.
→
†Cleaning the drain pump", page 36
▶
Pump is active, the water is being pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
Set a lower spin speed for the next wash.
▶
The load quantity is too high.
Reduce the load during the next wash.
▶
Unsuitable program set for the type of fabric.
TroubleshootingNL
45
Advertisement
Table of Contents
