Table of Contents
Advertisement
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the wash
cycle.
Cause and Troubleshooting
Remove unauthorized extensions from the water
▶
drain hose.
→
†Connecting the device", page 16
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The pump cover handle
must be vertical.
Start/Reloadwas not pressed.
PressStart/Refill.
▶
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or pinched.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The foam control system provides an extra rinse if the
foam is too high.
No error - no action required.
▶
TroubleshootingNL
43
Advertisement
Table of Contents
