Table of Contents
Advertisement
NLTroubleshooting
Malfunction
"E:36 / -10"
"E:38 / -25 / -26"
"E:60 / -2B"
burns.
40
Cause and Troubleshooting
Remove unauthorized extensions from the water
▶
drain hose.
→
†Connecting the device", page 16
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The pump cover handle
must be vertical.
Drain pump is clogged.
→ †Cleaning the drum", page 35
▶
if the fault is displayed again,
→
†Cleaning the drain pump", page 36
▶
Inlet opening of the rubber sleeve is clogged.
→ †Clean the inlet opening in the rubber sleeve",
▶
page 38
The imbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or pinched.
Water level measuring system defective.
Please contact customer service.
▶
→
†Customer Service", page 49
Temperature is too high.
Wait for the temperature to drop.
▶
→ †program cancel", Page 33
▶
Water level is too high.
Select a suitable program for draining.
▶
→ †Programs", Page 26
Advertisement
Table of Contents
