Set-Up; Powering The Weather Station; Installing The Homgar Tm -App; Pairing The Weather Station With The App - Bresser HomGar 7510100 Instruction Manual

SET-UP

POWERING THE WEATHER STATION

1. Plug the DC plug into the socket on the weather station.
2. Insert the mains plug into the power outlet. The device is
powered on directly.
3. Wait until indoor temperature and humidity as well as air
pressure are displayed on the weather station.
NOTE: Mains power is recommended for continuous
operation. Alternatively, operation with batteries is also
possible in order to maintain the time setting in the event of a
power failure. Note that the display automatically switches to
power-saving mode after 20 seconds when on battery power.
To supply power with batteries, follow these steps:
1. Remove the battery cover.
2. Place the batteries in the battery compartment. Observe
the correct alignment of the battery terminals (+/-).
3. Replace the battery cover.
4. Wait until indoor temperature and humidity as well as air
pressure are displayed on the weather station.
NOTE: When changing the type of power supply (mains power
or batteries), the power supply is temporarily interrupted for
technical reasons. All previous settings are lost. Exception:
permanent battery operation.
INSTALLING THE HOMGAR
The following requirements must be met to successfully
connect to your WiFi:
• The weather station only connects to the internet on the
2.4 GHz WiFi frequency. Most routers make the correct
connection automatically. If this is not the case, you can
usually make a manual adjustment on the router.
• Please connect the weather station to the mains via a
power cable if you want to establish and maintain the WiFi
connection.
• iOS minimum requirement: Mobile device with iOS 11.0
(or higher) + mobile/WiFi function.
• Android minimum requirement: Mobile device running
Android OS 6.0 (or higher) + mobile/WiFi function.
Tips:
• Don't use public WiFi networks.
• If you need to change WiFi networks, press and hold [+/
button and reconnect to HomGar
WiFi network's login information.
6
-APP
TM
]
APP, enter your new
TM
HomGar app downloads:
TM
or scan the QR code to download:
1. Open the HomGar app on your mobile device.
TM
2. Follow the instructions in the app to create an account. If
you already have an account, sign in using your existing
login details.
PAIRING THE WEATHER STATION
WITH THE APP
NOTE: The weather station and your mobile device must be less
than 10 feet apart during set-up.
There are two ways to pair the weather station with the app:
Method 1: Smart WiFi Connection Mode
Open the app and on the home page, tap the "+" in the upper-
right corner.