Table of Contents
Advertisement
Available languages
Available languages
WATER TIMER
Both the 1-zone water timer and the 2-zone water timer allow you to control the water supply manually without an app.
1-zone water timer
•
Press the Pair/Irrigation button to start watering
•
Press the Pair/Irrigation button again to stop watering.
2-zone water timer
•
Press the irrigation button for the left port to start irrigation through the left port. Press the irrigation button for the right port
to start irrigation through the right port.
•
Press the irrigation button for the left port again to stop watering through the left port. Press the irrigation button for the
right port again to stop watering through the right port.
TROUBLESHOOTING & NOTES
Troubleshooting
Problem
Weather Station Gateway Power
problem
Outdoor sensor drains batteries quickly
Disconnection
Device offline
The page displays the tempera-
ture value HH.H/LL.L
Inaccurate Temperature/Humidity
Reading
22
1. This weather station is designed to use a power adapter (5V)
as the main power source and batteries are only used as a
backup.
2. Replace the power adapter. It is important to use the correct
adapter on all electronic equipment.
* Check the distance and resistance between the outdoor
sensor and the weather station. Outdoor sensors at the end of
the range may work while batteries are fresh but not after they
drain a bit.
* Check for leaking batteries, which may damage the outdoor
sensor.
* Battery life is more than 12 months when using branded
alkaline batteries.
* Connection problems are often resolved by changing batteries
* Distance/Resistance can cause loss of connection between the
sensors/sub-devices and the weather station gateway.
* Rotate the weather station gateway 90 degrees toward the
sensors/sub-devices for better reception. This allows more
antenna surface to face the sensors/sub-devices signal.
* Try restarting the device and reconnecting.
1. Check if the battery is fully charged or the power supply is
normal.
2. Poor network signal or too far from the router.
HH.H/LL.L is an indication when the temperature is higher/lower
than the detection range.
When the indoor temperature/humidity is inaccurate, it is
often due to the location of the display or overpowered/under
powered batteries.
Solution
Advertisement
Table of Contents
